zeejet
Mame
This is a long one - apologies upfront. If TLDR, please see the last section (Draft Plan).
After extensive readings through existing threads on this forum and r/bonsai (Reddit), I’m still a bit unclear and apprehensive about how to approach bonsai stock growth/development (size, trunk, nebari, etc). I’m seeking reasonable growth rates in containers (I have a balcony) preferably with relatively simple setups.
I’ve tried to summarize my understanding/assumptions below and would appreciate a fact check where possible. I then propose a draft plan for growing in containers and a few lingering questions.
Core Concepts:
Conflicting or unproven concepts/theories:
After extensive readings through existing threads on this forum and r/bonsai (Reddit), I’m still a bit unclear and apprehensive about how to approach bonsai stock growth/development (size, trunk, nebari, etc). I’m seeking reasonable growth rates in containers (I have a balcony) preferably with relatively simple setups.
I’ve tried to summarize my understanding/assumptions below and would appreciate a fact check where possible. I then propose a draft plan for growing in containers and a few lingering questions.
Core Concepts:
- For overall growth/size, put it in the ground (field growing).
- With “unlimited” real estate for root growth (which is mirrored in the growth above ground), field growing is the fastest way to build overall mass.
- Drainage in-ground is more self-regulating - again, due to “unlimited” real estate - with lower likelihood of over or underwatering.
- An oversized pot is NOT a substitute for field growth.
- A large pot does not drain the same way in-ground soil drains and is harder to balance moisture when oversized relative to the tree.
- Tends to retain moisture too long and does not allow roots to breath due to lack of wet/dry cycle.
- Poor moisture balance hinders root development, which in turn hinders overall mass development.
- Use of containers with open boundaries such as colanders, pond baskets, grow bags, and Anderson flats allow roots to grow beyond the periphery.
- Exposed roots through these openings dry out and are “air pruned”.
- Air pruning prompts development of finer root structure within the container as the tree is not finding water/nutrients beyond the container in its current rooting strategy.
- Finer root structures promote foliar mass, which in turn promote overall mass through trunk and branches.
- For nebari development, use shallow containers or other methods for restricting vertical root growth (e.g. ebihara) while encouraging radial/horizontal root growth.
- To promote radial growth, vertical center roots are pruned each repotting
- A hard barrier (such as a tile or piece of flat wood) can be affixed to the base of the tree to encourage radial roots to grow outwards by physically restricting vertical root access.
- For growth-oriented soil, some well-draining organic components may be desirable (although not necessary) for slow but consistent nutrient supply in conjunction with regular fertilizing.
- Pine or fir bark with similar particle size to inorganic components (⅛-¼”).
- A mix of equal parts pumice, scoria, and pine/fir bark is a potential starting point.
- Reuse of soil during repot/rootwork (every 2-3 years) possible with removal of broken-down organics and other fines (via sieving) before adding back fresh bark.
- Transition to complete inorganic mix during late development and refinement.
- Table below was found on these forums summarizing key soil properties:
Conflicting or unproven concepts/theories:
- Large grow bags may simulate certain traits of field growth
- Fabric wicks away water at the boundaries to improve aeration and moisture balance
- Roots are air-pruned when growing beyond the container.
- Pot-in-pot: the tree is planted in a container with open-structure boundaries (pond basket, colander, Anderson flat, grow bag, etc.), then placed atop/within a larger soil mass.
- Roots are allowed to continue growing beyond the container into the larger pot but the core root mass is contained for easier management and rootwork.
- Another approach is to use inorganic soil in a grow bag (drainage and aeration) that is then surrounded by organic soil in a larger pot for moisture retention.
- Light/water/nutrient management is just as, if not more, important than root real estate
- Coarser/aggregate soil promotes nebari while finer soil promotes feeder root development.
- Feeder roots improve overall mass while larger roots contribute to the nebari.
- Do shallow vs deep containers actually matter (if you diligently prune vertical roots or use the ebihara technique)?
- How much does the minutiae of specific potting strategies actually affect the outcomes? I’m really seeking to simplify the approach - buying multiple types of containers and soils is a bit overwhelming.
- Do I need to progress up in pot sizes? Or can I simply stick my trees in a large grow box or Anderson flats with a well-draining soil mix? Drainage seems to be the main issue with container vs field growing isn't it?
- Am I losing a lot of growth by not placing my Anderson flat on a larger soil mass? If so, can I stack an Anderson flat on top of another Anderson flat (both filled with soil) and secure them together?
- Repot currently small/underdeveloped trees (½-¾” trunks) in small pond baskets (7”x7”x4”, 0.9 gallons) to promote growth of fine root network through air pruning
- Use equal parts pumice, scoria, and pine/fir bark as initial growth substrate.
- Fertilize regularly throughout the growth seasons and adjust for winter months. Considering adding up to 5% horticultural charcoal for additional CEC but unsure if this is useful if I’m fertilizing regularly and have pine bark in the blend already.
- Repot and root work every 1-2 years depending on vigor of root growth
- Reuse inorganic soil but sieve for fines and refresh degraded bark with fresh bark
- Up pot to a larger pond basket (10”x10”x5”, 2.2 gallons) when fine root structure exhausts available real estate.
- Repeat until need to up pot again and move to Anderson flats (15.75”x15.75”x5”, 5.4 gallons)
- May need to move into larger grow box or stack flats if volume is insufficient for further trunk growth
- Grow until trunks are desired thickness (1.5”-3”)
- Transition to fully inorganic soil blend and begin late development.
- Repot into bonsai pot for refinement and display