My nursery stock Quercus Palustris Pin Oak

[MMJNICE]

This is a progression thread that is open to opinion of styling and care of this tree. I bought this nursery stock tree 4 years ago with it being little more then a long 6 foot stick in a pot with a mass of foliage 3/4th up the trunk. First thing I did was hard chop down to 13" inches to a shoot and tried to develop branching with zero succes. For the first year nothing really happened. Next spring i repotted the tree into the current pot in Acadama and bonsai chunky bonsai soil from an online store that was heavy in lava and pumice with a pretty severe root pruning for an oak and uncovered the very wide but weird base with two thick roots kinda crossing each other before fine roots that could sustained the tree where discovered. Over the next couple of years i learned that if I let the tree run a bit with longer shoots I could cut back and get finer ramification back behind the cut points. Doing all the cuts on the tree at one time to encourage a second flush somewhat partially defoliating the tree but leaving the leafs behind the cuts untouched. Doing selective pruning didn't give me good results by cutting one shoot and not another. With this technique slowly I begin getting branches and at most three flushes of growth a session. I wish I took pictures when I first started the tree but to be honest I didn't see this tree for having any promise. I've definitely learned that little by little if you keep at a tree you will hammer out a fairly presentable tree that resembles a bonsai if you don't give up. This tree all of a sudden started to look like a decent representative in miniature of what this trees look like growing in the open ground. Sort of a flame tree shape but with a slant.
I know it needs more work and branches on the right side of this picture that's something I'll be working on this coming growing season. Also the root base is covered to start a decent root spread even though it's got a weird base nice radial roots are still possible with this tree and I'm going to try. Also not sure what side i like more or what angle. The more straight up and down or slanting at its current angle. the tree is definitely a work in progress. But i see a decent future for it.

 

[Colorado]

Cool, can’t say that I’ve seen too many pin oak bonsai. Nice work!

I definitely prefer the angle in that first photo. Looks the most natural to me.

 

[MMJNICE]

Cool, can’t say that I’ve seen too many pin oak bonsai. Nice work!

I definitely prefer the angle in that first photo. Looks the most natural to me.

The first picture is the current front of the tree. But still think the second angle has a potential for becoming the new front because the base looks less awkward and doesn't look like someone who's about to pee pee on them selves.. haha... as weird as the tree it kinda still works for me ,,,my daughter thinks it looks like a ballerina doing some kind of pose.

 

[Shibui]

my daughter thinks it looks like a ballerina doing some kind of pose.

I see someone climbing over a wire fence.

 

[Gabler]

I think your first step should be to fix the roots. In the picture below, you'll see the root collar circled in red. Everything above that line is stem tissue. Everything below that line is root tissue. It is pretty much impossible to layer anything above that line, because oaks refuse to grow root tissue from the stem area. Below that line, oaks can sprout new roots. I would recommend that you layer the roots below the root collar in order to start building your future nebari. Be sure to bury the root collar itself, since it contains undifferentiated tissue, which can sprout both roots and stems. If you can get new roots at or below the root collar, you will significantly advance the tree.



Here's what I'd be aiming for: